Technical Information

Restoration

Whilst we aim to give every hold a new lease of life, unfortunately, there are some beyond saving.

We reserve the right to refuse to restore holds or volumes we deem to be unsafe.

Once restored, the responsibility of correctly attaching and assessing the structural quality of the hold or volume is that of the walls.

Installation

Syncro holds and restorations should only be used on a flat, climbing surface. The entire hold should fit on the surface.

All screw holes should be used. 4.5mm wood screws should be used, ensuring at least 20mm of thread penetrates the wall surface.

All holds should be installed only by persons of sufficient training and experience.

Cleaning & Maintenance

We recommend cleaning holds with a cold water jet wash. The use of hot water or acid-based cleaning solutions may affect hold texture and colour.

We advise inspection upon delivery and regular inspections from then on of all holds for cracks, chips, and sharp edges. If a product shows a crack in its structure, or if an attachment point is damaged in any way, the product must be discarded.

Misuse and handling without due care and attention can limit the lifespan of your holds. Store in a dry place, out of direct sunlight, and ensure holds are fully dried before entering storage.